How to transfer from my iOS device to another phone/tablet when the other device is not detected automatically?
Make sure PhotoSync is installed on both your source device and target device.
Run PhotoSync on both your source device and target device. Attention: Make sure both target and source devices are connected to the same Wi-Fi network.
Change to an album on your source device and tap the thumbnails of the photos and videos you want to transfer to select them. A red mark appears when tapping. To deselect photo and videos just tap again.
Tap the red sync button and then select your preferred action type: New, Selected, or All.
Select the destination of where you want to transfer to. Tap the Phone/Tablet button if you want to transfer to another phone/tablet.
It can happen that no target device is found because some Wi-Fi routers may not support the automatic device detection that PhotoSync uses. If your Wi-Fi allows access between devices in the same Wi-Fi network you can connect to the target device by entering the internet (IP) address of the device manually into PhotoSync. PhotoSync remembers this input and will find your device automatically the next time your try as long as the device uses the same address.
To manually enter the address of the target device please tap on the Add device manually (IP) link at the bottom of the device search window.
You will be presented with an input mask to enter the IP address and the port of the target device.
Please follow the instructions in that window and start PhotoSync on your target phone/tablet that will not be found, tap on the red transfer button on the target device and select the Receive tab.
Tap on Phone/Tablet to open the address information of the target device. It shows the IP address/name of the device and the communication port that PhotoSync uses on that device.
Now enter the IP address/name and port of the target device into the manually add device mask on your iOS device and press Done when you're ready.
Select your preferred target device from the list of your available PhotoSync client devices.
During the transfer process your device will show a transfer indicator that informs you about the target device and the ongoing transfer progress.